If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items on eBay, and to buy.
Doepfer famous and amazing clock divider mk2/ver2. Bought from Juno couple months ago and used it in a smoke free home studio since. Selling most of my modules so check my other listings for more…Comes with box, screws and power cable.
Here is what Doepfer says about this:
Module A-160-2 is an enhanced version of the standard clock divider A-160. The module is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly for rhythm uses. The Clock input will take any digital signal from, eg. LFO, MIDI sync, or the gate from a MIDI-CV interface. At the outputs, you have access to three sets of seven different sub-divided clock signals, from half the clock frequency down to 1/128. The low/high levels of the output signals are 0V and about +10V.
The A-160-2 also has a reset input. Whenever a reset signal is sensed, all outputs are set to certain levels which depend upon the selected mode.
These are the most important features of the module:
Three different sets of dividing factors, selected by a three-position switch at the front panel:- Power of two: 2, 4, 8, 16, 32, 64, 128- Prime numbers: 2, 3, 5, 7, 11, 13, 17- Integer: 2, 3, 4, 5, 6, 7, 8
Two output modes, selected by a two-position switch at the front panel:- Gate mode: outputs act like the outputs of typical binary dividers- Trigger mode: in this mode the outputs are AND-wired with the clock signal (i.e. the clock pulsewidth affects the pulsewidth of the outputs)- Clock edge type selected by a jumper on the pc board:- Positive: the rising edge of the clock signal triggers the state change of the outputs- Negative: the falling edge of the clock signal triggers the state change of the outputs
Reset behaviour by two jumpers on the pc board:- Level triggered: the level at the Reset input triggers the Reset- Edge triggered: the edge of the signal at the Reset input triggers the Reset- Positive: a high level (> 2.5V) or the rising edge at the Reset input triggers the Reset- Negative: a low level (< 1 V) or the falling edge at the Reset input triggers the Reset
Output polarity selected by a jumper on the pc board:- Positive: non-inverted outputs- Negative: all seven outputs are inverted
Width: 4HP / 20mmDepth: 35mm (Measured from the rear side of the front panel)Current: +12V: +50mA, -12V: -0mA
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to buy, and to see similar items on eBay
Category: Musical Instruments:Pro Audio Equipment:Synthesisers and Sound Modules
Location: london, London