If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items on eBay, and to buy.
Tauntek Sequential Circuits Six-Trak OS v14 Firmware Upgrade EPROM
This mod fixes a bug in the original Six-Trak OS, and adds several new features, described by Tauntek as follows:Unison detune has been added. To allow storing the setting with the patch, I used the Oscillator Fine Tune parameter to control the detune amount. If the patch does not enable Unison mode, or if MIDI mode 4 is selected, this parameter works normally. When detune is enabled, oscillator fine tune amount is set to 0.Patches can now be selected using the value pot. In Program Select mode, the value pot will now scroll through the programs as it is turned. Two ranges are used. 0-59 and 40-99. When the pot is turned two steps beyond 59, the high range is selected. When it’s turned two steps below 40, we switch back to the low range. This may seem a little odd, but trying to cover the entire 0-99 range with the pot made the steps too close together and hard to control. Patches can also be selected using the keypad, as before.A new parameter (front panel #37 or MIDI #39) has been added. It’s global, and is not stored with each patch. In fact, it’s reset at power up. This parameter has three values, 0, 1, and 2. When it’s set to 0, all voice LFO’s behave normally. When it’s set to 1, all voice LFO’s are reset to the “no modulation” state when the voice is assigned. When it’s set to 2, all voice LFO’s are set to the “full modulation” state when the voice is assigned. So this parameter allows the LFO’s to sync to the start of a new note. It can be controlled using MIDI, the same as other parameters, but there is only one of them, not one per voice. So all voices will have the same setting.Be sure to take note of the marked orientation notch on the side of the EPROM to ensure correct installation. EPROMS inserted backwards will be destroyed. Incorrect insertion of ICs is also likely to cause damage to the board.
Will ship worldwide. Free pickup also available Fitzroy, Melbourne.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to buy, and to see similar items on eBay
Category: Musical Instruments:Pro Audio:Synthesisers
Location: Fitzroy North